Man, it's hard to get motivated with this cold weather. I didn't get anything done before the New Year trip, but so it goes.
My replacement Chrysler projectors came and I got one installed. They're real easy on the car, the door already has a courtesy light shining down. I mounted the projector (they're about 3/4" x 1.5 inches) in the door trim plastic, and wired it to the courtesy light. It took about 20 minutes. The bottom of the trim pulled away far enough to get the job done without removing the whole thing.
I left the original light there, and the projector is about 10 inches away from it. The logo really pops when the light is blocked, but the light is nice to have too, so I left it. I can always duct tape over it, or toss the bulb out.
On the Jeep, I'm going to have to fish wiring to the courtesy light under the dash since there's no door light. (I'd have swore there was one there) I think the edge of the plastic door trim will be wide enough.
The trouble with working in the shop is when I run the kerosene torpedo heater, after a while I start getting gassed. When it warms up, I'll be more excited about installing the things.
The things are COOL. When the 300's door is opened, the Chrysler logo "slides out" as if attached to something solid.