Jeep Commander Forum banner

Commander: TPMS Solutions... Please help (again)!

2K views 2 replies 2 participants last post by  clapperc 
#1 · (Edited)
Questions:

Description: Random failed connectivity error message / -- Displays.

History: All four sensors have been replaced twice; Once with aftermarket, now Mopar.
>> Do I understand correctly that after replacing... Sensors will sync-up with no special programming?

Action: Dealer software flash as per TSB 2305605. Although no way to confirm.
>> TSB also recommends to install a "fuse"... Dealer reports I already have one. Where is this "fuse"?

Note: 315MHz sensors.
>> A local WCM non-dealer guru reports that after Jeep's massive roll-out of TPMS's... Problems initiated a change from 315MHz to 433MHz. True or false?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top