transmission codes - Jeep Commander Forums: Jeep Commander Forum
Jeep Commander Jeep Commander Header Right
HomeForumGalleryClassifiedsAbout UsAdvertiseContact Us

» Auto Insurance
» Featured Product
Wheel & Tire Center

» Sponsor Links
Go Back   Jeep Commander Forums: Jeep Commander Forum > Jeep Commander Discussion > Problems / Dealer Service

Problems / Dealer Service Having a problem with your vehicle? Were you treated fairly or poorly at a dealer? Warranty issues? Let us know.

JeepCommander.com is the premier Jeep Commander Forum on the internet. Registered Users do not see the above ads.
Reply
 
Thread Tools Display Modes
  #1  
Old 09-29-2009, 12:09 AM
psmith994 psmith994 is offline
Junior Member
Points: 2,242, Level: 28 Points: 2,242, Level: 28 Points: 2,242, Level: 28
Level up: 62% Level up: 62% Level up: 62%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Aug 2009
Posts: 13
transmission codes

so i now have tranny code U0404 and P0700. I know that the U0404 code is the shifter assembly. Any ideas on how to change one of these out? And the P0700 could be multiple trans reasons. My trans has no problems at all in shifting up or down and it doesn't overheat.

any help here would appreciated.

Next is how the heck do i check my trans fluid w/o buying Jeeps 74.00 tool/part.

thanks!
Reply With Quote
Sponsored Links
Advertisement
 
  #2  
Old 09-29-2009, 12:15 AM
a49erFan's Avatar
a49erFan a49erFan is offline
Administrator
Points: 55,720, Level: 100 Points: 55,720, Level: 100 Points: 55,720, Level: 100
Level up: 0% Level up: 0% Level up: 0%
Activity: 7% Activity: 7% Activity: 7%
 
Join Date: Jan 2007
Location: Sunny Arizona
Posts: 12,554
Send a message via Yahoo to a49erFan
What year is your Commander and is it no longer under warranty?
Reply With Quote
  #3  
Old 09-29-2009, 07:57 AM
tripod tripod is offline
Senior Member
Points: 4,505, Level: 42 Points: 4,505, Level: 42 Points: 4,505, Level: 42
Level up: 78% Level up: 78% Level up: 78%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Apr 2008
Posts: 282
theres close to a gillion transmission tsb's. what tranny, what engine, and what year. Mileage?
__________________
06 5.7 Limited,QDII,blk/sdl lthr,nav/ves,chrome tow hooks,DUB grill,weathertech cargo mat,rubber antenna,PIAA intense white/low & super plasma/high, Trueflow panel fltr,Hankook Dynapros,Thule/Mopar 687 cargo pod
Reply With Quote
  #4  
Old 09-29-2009, 09:42 AM
psmith994 psmith994 is offline
Junior Member
Points: 2,242, Level: 28 Points: 2,242, Level: 28 Points: 2,242, Level: 28
Level up: 62% Level up: 62% Level up: 62%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Aug 2009
Posts: 13
ha! my bad guys....06 commander, 3.7l motor, 2wd, no longer under warranty....anybody ever use those auto warranty's that you see on the tv?
Reply With Quote
  #5  
Old 09-29-2009, 11:08 AM
Fstop28's Avatar
Fstop28 Fstop28 is offline
Member
Points: 1,616, Level: 23 Points: 1,616, Level: 23 Points: 1,616, Level: 23
Level up: 16% Level up: 16% Level up: 16%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Aug 2009
Location: Midland TX
Posts: 66
I got the same codes last night...I found this thread for the same codes...

http://www.jeepcommander.com/forums/...=trouble+codes

Seems to involve replacing the Shifter Bezel. Chrysler has four parts listed two each for the A580 Transmission (with and without Transfer Case Switch) and two for the 545RFE Transmission (again with and without Transfer Case Switch)

Any one know which Trans I have?

2006 3.7 4x4 Quad-trac II. Any Help?
Reply With Quote
  #6  
Old 12-29-2009, 09:09 PM
tydougherty tydougherty is offline
Junior Member
Points: 6, Level: 1 Points: 6, Level: 1 Points: 6, Level: 1
Level up: 11% Level up: 11% Level up: 11%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Dec 2009
Posts: 2
Tranny troubles code P0700 and P0730

2006 commander
2wd V6 just over 50,000 miles

Started having transmission issues..

Symptoms include..
Jeep gets stuck in gear, not sure which one, but shows D on the display not the normal 3 for limp home mode. I will have to pull over and shut off the vehicle and restart for it to "reset" and shift properly. The vehicle will not upshift or downshift. When it gets stuck in gear and i stop at a light it will take alot of gas to get going..

It also will sometimes slip out of gear totally but still show drive..

Stopped today at autozone and they pulled off a P0730 which is incorrect gear ratio and P0700..

have not had any tranny work done since i have owned it..

I read all the threads on the other tranny issues but none seem to show the P0730 code..
Reply With Quote
  #7  
Old 12-29-2009, 09:53 PM
a49erFan's Avatar
a49erFan a49erFan is offline
Administrator
Points: 55,720, Level: 100 Points: 55,720, Level: 100 Points: 55,720, Level: 100
Level up: 0% Level up: 0% Level up: 0%
Activity: 7% Activity: 7% Activity: 7%
 
Join Date: Jan 2007
Location: Sunny Arizona
Posts: 12,554
Send a message via Yahoo to a49erFan
Merged threads, check out the link in post #5 and see if that helps.
Reply With Quote
  #8  
Old 12-29-2009, 10:11 PM
tydougherty tydougherty is offline
Junior Member
Points: 6, Level: 1 Points: 6, Level: 1 Points: 6, Level: 1
Level up: 11% Level up: 11% Level up: 11%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Dec 2009
Posts: 2
Quote:
Originally Posted by a49erFan View Post
Merged threads, check out the link in post #5 and see if that helps.
Not really.. I read all those threads..

I am throwing an incorrect gear ratio P0730 that no one else has.. hence my new thread..

P0730 was the first code and the P0700 was the resultant code.. I understand that you will get P0700 with many other transmission related codes..

That isnt the real issue. the P0730 is the issue.. How does your gear ratio become incorrect?? out of the blue..
Reply With Quote
Sponsored Links
Advertisement
 
Reply

  Jeep Commander Forums: Jeep Commander Forum > Jeep Commander Discussion > Problems / Dealer Service


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Powered by vBadvanced CMPS v3.2.2

All times are GMT -5. The time now is 03:40 AM.



Powered by vBulletin®. Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.