Seat Belt Chime, Annoying!! - Jeep Commander Forums: Jeep Commander Forum
Electronics / NAV Discussion This section contains discussion about the electronics system and NAV system in the Jeep Commander.

 
LinkBack Thread Tools Display Modes
post #1 of 10 (permalink) Old 09-09-2011, 02:22 PM Thread Starter
Junior Member
Points: 4, Level: 1 Points: 4, Level: 1 Points: 4, Level: 1
Level up: 7% Level up: 7% Level up: 7%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Sep 2011
Posts: 1
Seat Belt Chime, Annoying!!

I just bought a used 2007 Jeep Commander Limited. I normally wear my seatbelt, however my dog doesn't when he sits in the passenger seat. This activates the seat belt fasten chime. I tried the following steps which everyone else has listed but did not work, any other suggestions?

(Steps followed that did not work)
The following steps must occur within the first 60 seconds of the ignition switch being turned to the ON or START position. The manufacturer does not recommend deactivating the Enhanced Warning System (BeltAlert)

1. Turn the ignition switch to the OFF position, and fasten the driver's seat belt.

2. Start the engine, and wait for the Seat Belt Warning Light to turn off.

3. Within 60 seconds of starting teh vehicle, unbuckle and re-buckle the driver's seat belt at least three times, ending with the seat belt buckled, within 10 seconds.

4. Turn off the engine. A single chime will sound to signify that you have successfully completed the programming.

The Enhanced Warning System (BeltAlert) can be recactivated by repeating this procedure.
jeepman1 is offline  
Sponsored Links
Advertisement
 
post #2 of 10 (permalink) Old 09-09-2011, 03:46 PM
Senior Member
Points: 10,142, Level: 67 Points: 10,142, Level: 67 Points: 10,142, Level: 67
Level up: 23% Level up: 23% Level up: 23%
Activity: 0% Activity: 0% Activity: 0%
 
Fohn_Jargo's Avatar
 
Join Date: Apr 2007
Location: Bella Vista, AR
Posts: 1,418
You could just leave the seatbelt buckled.

I have to do that once in a while if I drive to one of our customers offices and I have one of our project managers with me. He used to be a tight end for the Arkansas Razorbacks.


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Fohn_Jargo is offline  
post #3 of 10 (permalink) Old 09-09-2011, 04:02 PM
Senior Member
Points: 4,992, Level: 45 Points: 4,992, Level: 45 Points: 4,992, Level: 45
Level up: 21% Level up: 21% Level up: 21%
Activity: 0% Activity: 0% Activity: 0%
 
Smitty1970's Avatar
 
Join Date: Feb 2009
Location: Palmyra , Va.
Posts: 1,096
Go to a salvage yard and cut one of the buckles out, keep it on hand and just plug it in.

American by birth, Southern by the grace of God.
Smitty1970 is offline  
 
post #4 of 10 (permalink) Old 09-09-2011, 08:38 PM
Senior Member
Points: 11,816, Level: 71 Points: 11,816, Level: 71 Points: 11,816, Level: 71
Level up: 42% Level up: 42% Level up: 42%
Activity: 0% Activity: 0% Activity: 0%
 
robby's Avatar
 
Join Date: Jun 2008
Location: Desplaines IL.
Posts: 3,262
Quote:
Originally Posted by jeepman1 View Post
I just bought a used 2007 Jeep Commander Limited. I normally wear my seatbelt, however my dog doesn't when he sits in the passenger seat. This activates the seat belt fasten chime. I tried the following steps which everyone else has listed but did not work, any other suggestions?

(Steps followed that did not work)
The following steps must occur within the first 60 seconds of the ignition switch being turned to the ON or START position. The manufacturer does not recommend deactivating the Enhanced Warning System (BeltAlert)

1. Turn the ignition switch to the OFF position, and fasten the driver's seat belt.

2. Start the engine, and wait for the Seat Belt Warning Light to turn off.

3. Within 60 seconds of starting teh vehicle, unbuckle and re-buckle the driver's seat belt at least three times, ending with the seat belt buckled, within 10 seconds.

4. Turn off the engine. A single chime will sound to signify that you have successfully completed the programming.

The Enhanced Warning System (BeltAlert) can be recactivated by repeating this procedure.
You are misinterpeting the proceedure.
Get in, close door, fasten belt, turn key to 'on' position....do not start.
Unbuckle, re-buckle three times, ending with belt buckled.
Turn off key and unbuckle belt.
The chime may or may not sound.

Once successfully re-programmed, the chime will sound at startup if the belt is not buckled but once it has chimed a few seconds it will shut off.
The light will stay on.
The chime will not sound again untill the next startup cycle.

Took me about three attempts on my 07 but persistance paid off.

Search some of the old seat belt chime threads.....you'll see many members had to try it several times before they succeeded.

Rob


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
|
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
robby is offline  
post #5 of 10 (permalink) Old 09-09-2011, 09:26 PM
Senior Member
Points: 2,792, Level: 32 Points: 2,792, Level: 32 Points: 2,792, Level: 32
Level up: 28% Level up: 28% Level up: 28%
Activity: 0% Activity: 0% Activity: 0%
 
Holaday07 4.7's Avatar
 
Join Date: Jan 2011
Location: St. Louis
Posts: 284
This is the best thread I have ever seen. I did not know there was a solution for getting rid of that!

2007 Jeep Commander: QTII, Leather, Sunroof, remote start, OEM Skid Plates


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


2 in Daystar lift, 255.75.17 BFG Muds, 1.25 " Spidertrax wheel spacers, 4x Guard front Guard & Side Guards, Optima Red Top, Bilstein 5150 Rear shocks, Robby's front leveling spacer, Pinch weld mod and trimming!
Holaday07 4.7 is offline  
post #6 of 10 (permalink) Old 02-15-2012, 08:01 PM
Senior Member
Points: 1,706, Level: 24 Points: 1,706, Level: 24 Points: 1,706, Level: 24
Level up: 6% Level up: 6% Level up: 6%
Activity: 0% Activity: 0% Activity: 0%
 
mrnavy2's Avatar
 
Join Date: Jan 2012
Location: New Jersey
Posts: 244
Send a message via AIM to mrnavy2
Thanks for the info.

Once a Battleship Sailor always a Battleship Sailor.

I am US Navy Retired, 1976 - 1996
and Proud to have served

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
OUR COUNTRY
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
mrnavy2 is offline  
post #7 of 10 (permalink) Old 02-15-2012, 08:10 PM
Junior Member
Points: 2,796, Level: 32 Points: 2,796, Level: 32 Points: 2,796, Level: 32
Level up: 31% Level up: 31% Level up: 31%
Activity: 0% Activity: 0% Activity: 0%
 
mikein210's Avatar
 
Join Date: Feb 2011
Posts: 10
You can join the wires under the seat coming off the belt. It works great never hear that chime again.

Sent from my Nexus S 4G using AutoGuide.com App
mikein210 is offline  
post #8 of 10 (permalink) Old 02-15-2012, 08:13 PM
Senior Member
Points: 10,542, Level: 68 Points: 10,542, Level: 68 Points: 10,542, Level: 68
Level up: 23% Level up: 23% Level up: 23%
Activity: 0% Activity: 0% Activity: 0%
 
JeepJorge's Avatar
 
Join Date: Jan 2011
Location: Rowlett, Texas
Own a Commander?: Yes
Model year: 2006
Trim Package: Limited
Power-Train: 5.7L V-8 Hemi
2WD
If 4WD - system: QD-II
Posts: 537
Awesome thread

2006 Limited, Light Khaki Metallic, Light Graystone/Dark Khaki Leather, HEMI, QDII, Rear DVD, REC Nav w/09 Database, woody side, EGR hood deflector, AEM Gun Metal Brute Force CAI, tilting rearview mirrors.
“I did not enter politics out of philanthropy but rather as an extension of my own annoyance at having inherited freedoms infringed by power-crazed idiots spouting gibberish”. Nigel Farage MEP; Leader, UK Independence Party
JeepJorge is offline  
post #9 of 10 (permalink) Old 02-20-2012, 12:05 PM
Senior Member
Points: 12,485, Level: 73 Points: 12,485, Level: 73 Points: 12,485, Level: 73
Level up: 9% Level up: 9% Level up: 9%
Activity: 0% Activity: 0% Activity: 0%
 
filo8818's Avatar
 
Join Date: May 2010
Location: Milano, Italy
Posts: 532
woow good to know..i ll try it later if the procedure is working..thanks
filo8818 is offline  
post #10 of 10 (permalink) Old 02-21-2012, 08:53 AM
Senior Member
Points: 12,485, Level: 73 Points: 12,485, Level: 73 Points: 12,485, Level: 73
Level up: 9% Level up: 9% Level up: 9%
Activity: 0% Activity: 0% Activity: 0%
 
filo8818's Avatar
 
Join Date: May 2010
Location: Milano, Italy
Posts: 532
ok on my jeep is not working. i try 5 times to do it but nothing....strange..btw it supposed to work just for one ride and not forever?
filo8818 is offline  
Sponsored Links
Advertisement
 
Reply

  Jeep Commander Forums: Jeep Commander Forum > Jeep Commander Discussion > Electronics / NAV Discussion

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Jeep Commander Forums: Jeep Commander Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in











Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome