Electric window issue - Jeep Commander Forums: Jeep Commander Forum
Electronics / NAV Discussion This section contains discussion about the electronics system and NAV system in the Jeep Commander.

 
LinkBack Thread Tools Display Modes
post #1 of 6 (permalink) Old 01-17-2012, 05:03 PM Thread Starter
Junior Member
Points: 1,371, Level: 20 Points: 1,371, Level: 20 Points: 1,371, Level: 20
Level up: 72% Level up: 72% Level up: 72%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Jul 2011
Posts: 5
Electric window issue

I can roll my front passenger window up and down from either front side window switch. However, regardless if I use lt ot rt side the pass window automaticly rolls down after going up. The only way to prevent it is to tap the switch when the window is up. Again same results if using drivers or passenger switch. Any ideas as to whats wrong? Thanks
jeepjunky is offline  
Sponsored Links
Advertisement
 
post #2 of 6 (permalink) Old 01-17-2012, 06:29 PM
Moderator
Points: 10,821, Level: 68 Points: 10,821, Level: 68 Points: 10,821, Level: 68
Level up: 93% Level up: 93% Level up: 93%
Activity: 0% Activity: 0% Activity: 0%
 
SAL-XK's Avatar
 
Join Date: Apr 2010
Location: North Carolina
Posts: 1,993
The safety switch is tripping it sound like. The window will only go up with so much force if that limit is reached it rolls back down for safety. Have a good look in the channel and all around make sure nothing has been lodged any where.


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Stop by and like the page

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
SAL-XK is offline  
post #3 of 6 (permalink) Old 01-17-2012, 07:06 PM
Super Moderator
Points: 59,277, Level: 100 Points: 59,277, Level: 100 Points: 59,277, Level: 100
Level up: 0% Level up: 0% Level up: 0%
Activity: 100% Activity: 100% Activity: 100%
 
jeep5253's Avatar
 
Join Date: Jun 2006
Own a Commander?: Yes
Model year: 2006
Trim Package: Limited
Power-Train: 5.7L V-8 Hemi
4WD
If 4WD - system: QD-II
Posts: 14,877
Quote:
Originally Posted by jeepjunky View Post
I can roll my front passenger window up and down from either front side window switch. However, regardless if I use lt ot rt side the pass window automaticly rolls down after going up. The only way to prevent it is to tap the switch when the window is up. Again same results if using drivers or passenger switch. Any ideas as to whats wrong? Thanks
See this TSB---> http://www.xkjeeps.com/tsb/tsb_xk_2303207.pdf

Try resetting the window module by doing the procedure below. If that doesn't work you maty need to replace the regulator.

To reset the express-up module for the door window glass in question:

A. First, disable (de-normalize) the express-up feature: Drive the glass into the full-up
position by pulling up on the window switch to its first detent (manual mode) and
holding switch until the glass is fully closed.

B. Drive the glass to the full-down position by pushing down on (depress) the window
switch until the window glass is fully open. Do not release the window switch.
Continue to hold the window switch down for 30 seconds after the window glass is
fully open. (Ensure door module is de-normalized by pulling up on the window
switch to the second detent (express mode) and verifying the window does
not go into the express up mode. If the window goes into express mode,
repeat step b. If the window does not go into express mode proceed to next
step.)

C. Reset (normalize) the express-up module for the door window glass in question:
Drive the glass into the full-up position by pulling up on the window switch to its first
detent (manual mode) and holding up on the switch for at least one (1) full second
after the window glass has fully closed.

2006 Steel Blue 5.7L HEMI Limited 4x4 Build Date: June 9, 2006 Hour 14
Interior: Dark Slate/Light Graystone with Saddle Brown Leather Seats
Quadra-Drive II, NAV, DVD, Trailer Tow Group IV, Off-Road Group II, Remote Start, UConnect, Rear Backup Camera, Chrome Wheels,
Magnaflow cat-back exhaust, Daytime Running Lights enabled, 2" Rough Country Lift with 265/70R17 Goodyear Wrangler AT/S
jeep5253 is offline  
 
post #4 of 6 (permalink) Old 01-18-2012, 09:35 AM Thread Starter
Junior Member
Points: 1,371, Level: 20 Points: 1,371, Level: 20 Points: 1,371, Level: 20
Level up: 72% Level up: 72% Level up: 72%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Jul 2011
Posts: 5
Thanks 5253, your directions worked awsome!
jeepjunky is offline  
post #5 of 6 (permalink) Old 01-18-2012, 04:12 PM
Super Moderator
Points: 59,277, Level: 100 Points: 59,277, Level: 100 Points: 59,277, Level: 100
Level up: 0% Level up: 0% Level up: 0%
Activity: 100% Activity: 100% Activity: 100%
 
jeep5253's Avatar
 
Join Date: Jun 2006
Own a Commander?: Yes
Model year: 2006
Trim Package: Limited
Power-Train: 5.7L V-8 Hemi
4WD
If 4WD - system: QD-II
Posts: 14,877
Quote:
Originally Posted by jeepjunky View Post
Thanks 5253, your directions worked awsome!
You're welcome ! Another satisfied customer.

2006 Steel Blue 5.7L HEMI Limited 4x4 Build Date: June 9, 2006 Hour 14
Interior: Dark Slate/Light Graystone with Saddle Brown Leather Seats
Quadra-Drive II, NAV, DVD, Trailer Tow Group IV, Off-Road Group II, Remote Start, UConnect, Rear Backup Camera, Chrome Wheels,
Magnaflow cat-back exhaust, Daytime Running Lights enabled, 2" Rough Country Lift with 265/70R17 Goodyear Wrangler AT/S
jeep5253 is offline  
post #6 of 6 (permalink) Old 05-13-2012, 08:13 PM
Junior Member
Points: 2, Level: 1 Points: 2, Level: 1 Points: 2, Level: 1
Level up: 3% Level up: 3% Level up: 3%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: May 2012
Location: Middle Tennessee
Posts: 1
I had the same problem on my Commander. This solution fixed it!! Thanks Jeep5253!!
JeepGirl76 is offline  
Sponsored Links
Advertisement
 
Reply

  Jeep Commander Forums: Jeep Commander Forum > Jeep Commander Discussion > Electronics / NAV Discussion

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Jeep Commander Forums: Jeep Commander Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in











Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome