Air flow in vents. - Jeep Commander Forums: Jeep Commander Forum
General Commander Discussion General Discussion involving the Jeep Commander goes here. If it does not fit into a more specific category below, post it here.

 1Likes
  • 1 Post By PaulD
 
LinkBack Thread Tools Display Modes
post #1 of 2 (permalink) Old 09-29-2017, 07:39 AM Thread Starter
Junior Member
Points: 127, Level: 2 Points: 127, Level: 2 Points: 127, Level: 2
Level up: 54% Level up: 54% Level up: 54%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Sep 2017
Location: Littleton Co
Own a Commander?: Yes
Model year: 2006
Trim Package: Sport
Power-Train: 4.7L V-8
4WD
Current Mileage: 161000
Posts: 6
Air flow in vents.

I have a 2006 commander 4.7 when I turn the knob for the air control from floor to vents to defrost I can hear the motor turn but get no air out of any of the positions? What is causing this to happen? Thank you for the help
Dubbs1977 is offline  
Sponsored Links
Advertisement
 
post #2 of 2 (permalink) Old 09-29-2017, 10:08 AM
Member
Points: 796, Level: 14 Points: 796, Level: 14 Points: 796, Level: 14
Level up: 96% Level up: 96% Level up: 96%
Activity: 0% Activity: 0% Activity: 0%
 
Join Date: Sep 2017
Location: Arkansas
Own a Commander?: Yes
Model year: 2006
Trim Package: Limited
Power-Train: 5.7L V-8 Hemi
4WD
If 4WD - system: QD-II
Current Mileage: 112000
Posts: 99
I recently had to fix similar problem on my 06 XK. The HVAC doors are controlled by electrical actuators about the size of a pack of cigarettes. I had two with problems. The driver side of the HVAC unit has two actuators. One just behind the ignition key and the other slightly forward and higher. I think the higher/forward one operates the defroster door. Some of these actuators use a small gear between the actuator and the door. The original gear is very weak and prone to breakage. Replacement gears have corrected that weak gear problem. I had to replace the actuator behind the key because the actuator had a broken internal gear (makes lots of clacking noise). I have not needed to do anything with the other actuator on the driver side so I am not sure if it uses the external gear or not. However, your description matches what happened to me on the passenger side air recirculation door which uses the external gear. If you do not have dual A/C controls, then your air blend door (controls ratio of hot/cold air) operated from a single door controlled by the actuator behind the key. If you have dual temperature controls, then you have a separate air blend door for passenger side that is on passenger side across for the one behind the key. The blend doors are direct drive from the actuators with no added external gear. The other actuator on the passenger side is up high on big air box just above the passengers right foot. That box is the air recirculate door to let you choose between inside/outside air. That actuator used the external gear and that external gear is one I had to replace recently. That recirculate door acted the same way as you described so I am betting that the defrost door has a broken external gear on the actuator. The actuator was operating but it did not move the door because the external gear was broken.
I know this was a long winded story to get to your situation but I thought it would help understand what you see when you open everything up. To open the driver side, remove the two screws that hold up the black panel under the dash. The panel under the steering wheel just pulls down and is hinged on a pin. Lower the door all the way down then bump the hinge area and the door will pop loose from the hinge pins. All the actuators are the same (I used Dorman 604-006) and the gear is part number 68072190AA. Actuators are held in by 2 or 3 T-15 Torx screws while the external gear just slides on. Hope this helps
TwoBobsXK likes this.

06 Limited, 5.7L, 4x4, Light Khaki
89 Grand Wagoneer - everything works
PaulD is offline  
Sponsored Links
Advertisement
 
Reply

  Jeep Commander Forums: Jeep Commander Forum > Jeep Commander Discussion > General Commander Discussion

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Jeep Commander Forums: Jeep Commander Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in











Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome