Some great information about XK alignment - Jeep Commander Forums: Jeep Commander Forum
Suspension / Lifts This is the place to discuss the suspension, lift systems, and other stuff underneath your Jeep Commander

  • 1 Post By Legofan
LinkBack Thread Tools Display Modes
post #1 of 1 (permalink) Old 05-29-2018, 06:07 PM Thread Starter
Senior Member
Points: 2,938, Level: 33 Points: 2,938, Level: 33 Points: 2,938, Level: 33
Level up: 26% Level up: 26% Level up: 26%
Activity: 0% Activity: 0% Activity: 0%
Join Date: Oct 2017
Location: Evanston, IL
Own a Commander?: Yes
Model year: 2010
Trim Package: Sport
Power-Train: 3.7L V-6
If 4WD - system: QT-I
Current Mileage: 100k
Posts: 299
Some great information about XK alignment

Camber adjustment is made at the LCA (lower control arm) The bolts that anchor the LCA are in slots. Loosen and you can slide it in and out.

Camber and caster angle adjustments involve changing the position of the lower control arm with the slots in the frame brackets to move the lower control arm inwards or outwards for proper adjustment. This can be achieved by using a long pry bar with a curved tip and inserting the pry bar into the lower control arm frame brackets and prying inwards or outwards.

NOTE: Camber and caster adjustments must be made at the lower control arm. Do not use the upper control arm for Camber and Caster adjustments.

NOTE: When the lower control arm pivot bolts are loosened the lower control arm will normally go outwards automatically with the weight of the vehicle.

Moving the rear position of the lower control arm at the frame in or out, will change the caster angle significantly and camber angle only slightly. To maintain the camber angle while adjusting caster, move the rear of the lower control arm in or out. Then move the front of the lower control arm slightly in the opposite direction.

Move both the front and rear of the lower control arm together in or out. This will change the camber angle significantly and caster angle slightly.

After adjustment is made tighten the lower control arm bolt & nuts to FRONT169 Nm (125 ft. lbs.) and the REAR 88 Nm (65 ft. lbs.).
Zapa likes this.

Last edited by Legofan; 05-29-2018 at 06:09 PM.
Legofan is offline  
Sponsored Links

  Jeep Commander Forums: Jeep Commander Forum > Jeep Commander Discussion > Suspension / Lifts

Quick Reply

Register Now

In order to be able to post messages on the Jeep Commander Forums: Jeep Commander Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode

Posting Rules  
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome