Join Date: Jun 2006
Own a Commander?: Yes
Model year: 2006
Trim Package: Limited
Power-Train: 5.7L V-8 Hemi
If 4WD - system: QD-II
I cannot post into the maintenance forum, not really sure why
I removed the front driveshaft fully, and upon starting the car I found that it would not move unless it's in 4low. I believe that this truck has Quadra-Trac II, as it does not come with limited slip differentials. When I press the pedal in gear, I can hear a spinning from underneath the car but it will not move in drive or reverse. Is this because this car is FWD until it detects slipping, then gives power to the rear driveshaft? I would like to think it's not an issue with the transfer case, but I was under the impression that like most 4x4s you can drive it without the front driveshaft. Evidently not the case with this one.
Your Commander is Full Time 4WD, so it s not going anywhere without the front drive shaft. I don't know how it could move in 4Lo.
2006 Steel Blue 5.7L HEMI Limited 4x4 Build Date: June 9, 2006 Hour 14
Interior: Dark Slate/Light Graystone with Saddle Brown Leather Seats
Quadra-Drive II, NAV, DVD, Trailer Tow Group IV, Off-Road Group II, Remote Start, UConnect, Rear Backup Camera, Chrome Wheels,
Magnaflow cat-back exhaust, Daytime Running Lights enabled, 2" Rough Country Lift with 265/70R17 Goodyear Wrangler AT/S