Jeep Commander Forum banner
acceleration
1-4 of 4 Results
  1. Problems / Dealer Service
    Hello everyone. First post. I have a 2009 Commander V6 3.7 With 158510 miles. I was barely getting any power as I would accelerate from a stop. CEL came on, checked the codes and got Ignition Coil misfire in 5 and 6. I replaced all my spark plugs(since it was time anyways) as well as the 3...
  2. General Commander Discussion
    I have a 2007 Jeep Commander with the 3.7 v6. I have had issues where when I am driving and accelerating the car will accelerate and shift like normal at first, but sometimes the throttle just cuts out so the car won't go above 30MPH. When I push the gas pedal when this happens, the engine...
  3. General Commander Discussion
    I have a commander 2006, 3.7L. It is slow to accelerate and at 60MPH it will not shift into a higher gear and runs at 3000RPM. Transmission guys serviced it and said the trans is good. After the transmission service she ran better but within a day or two the same thing started happening...
  4. Regular Service / Maintenance
    4WD 3.7L The noise starts at about 55mph and is worse under bigger loads. in neutral and coasting, no noise. Vehicle has 145,000 miles. My guess is the front differential/driveline but I'm not sure where to even begin looking for issues. Thanks!
1-4 of 4 Results
Top