Jeep Commander Forum banner
electrical issue
1-2 of 2 Results
  1. New Member Section
    So long story short I drove to work, jeep ran fine there, went on first break jeep crank and ran fine, 2 hours later jeep panic lights are going off as if alarm was triggered so i try to start car (because my key fob don't work) it dose nothing but turn over and over no crank....so i thought it...
  2. Diagnostic Trouble Codes (DTC)
    Good morning. My 2006 Hemi Commander is tossing U1001, U0024, one for EGR system performance (sorry don't remember the code), along with other can B bus - for a lot of modules. This fall I noticed the mds would not engage. Check engine light came on so I hooked up my snapon scanner and seen...
1-2 of 2 Results
Top