Jeep Commander Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. Diagnostic Trouble Codes (DTC)
    Okay I have a 06 commander with 4.7 ho I have replaced injectors coils plugs when first start up runs and drives great once warm it has a cylinder 4 misfire big one it does misfire on 2-4-6-8 bank one does not misfire example cylinder 2-13missfires cylinder 4-1500missfires cylinder 6-8missfires...
  2. New Member Section
    Hey Everyone, New around here (I've lurked, but haven't posted yet...you've all already helped me more than I can express.) Recently purchased a 2007 XK 3.7 with QTi that wouldn't start, I replaced the fuel pump and got her to fire up, but she's not happy. Good news is I don't hear anything...
  3. New Member Section
    Hey everyone, I am new here and a new Jeep owner. I recently bought a 2007 Jeep Commander Limited 4.7L 4WD Flex Fuel with 240,000 miles on it. I love it and it was driving just fine. I got it at auction and it needed headlights, bumper and fender. Got all that replaced and it passed inspection...
  4. Problems / Dealer Service
    So I just recently picked up a 2006 jeep commander 4x4 with the 3.7 v6. When I start up it runs smooth but once it gets near or at operating temp it begins to misfire. I ran a scanner and it read a code for a cylinder 4 misfire but I pulled the plug in cylinder 4 and it was dry and the gap was...
  5. Problems / Dealer Service
    Hello everyone. First post. I have a 2009 Commander V6 3.7 With 158510 miles. I was barely getting any power as I would accelerate from a stop. CEL came on, checked the codes and got Ignition Coil misfire in 5 and 6. I replaced all my spark plugs(since it was time anyways) as well as the 3...
  6. Problems / Dealer Service
    Here I am Back again. New day New problem....So recently I had to replace the tail pipe from the muffler back on my 2007. The mount arms had broken at the weld on both spots. A week ago I cut the tail pipe off at my shop and drove it home no tailpipe. On the way home I started getting misfire...
  7. New Member Section
    Hello Everyone, I have a 2006 5.7L Commander that one morning started up rough and smoke started spewing out of the tailpipe a few moments later the check engine light went on Code P0307 and this started a week long drinking binge with me mostly staring out the window at the car and angrily...
  8. Problems / Dealer Service
    Hey everyone. I just signed up for this forum for one reason and that's because I need to pick some brains. My 08 commander with a 3.7 in it. Also has a few ticks under 135k miles on it. It has a misfire issue in 1,3,5. I've been trying to trace it but keep getting no where. So far I did the...
  9. Problems / Dealer Service
    Hello All, New to the forum here. Have a daily driver, bought new in 2007 in CA. Has 120,000 miles on it. No mods. Maintenance completed as required. Engine is the 4.7 VIN N (Non flex fuel). Vehicle developed hesitation last summer. Only when hot, the engine would stutter and miss...
  10. Problems / Dealer Service
    Hello all, I am having problems with my 2006 jeep Commander 4.7L. It is reading the code P0304 and another code(ican't remember what it was) but it pertained to coil pack D. I know it is a misfire and I can definitly feel it. It idles very rough, will not go past 2500 rpms, and stutters...
1-10 of 10 Results
Top