Jeep Commander Forum banner
starter
1-7 of 7 Results
  1. General Commander Discussion
    Just got off the phone with two dealers local to me. Both said the same thing: All OEM starters for our cars are reman now, as they (Chrysler) don't make them new anymore. Has anyone else heard this? I'm on the hunt for one (TODAY), and I got them to discount it by nearly $100 after some polite...
  2. Problems / Dealer Service
    Had an interesting evening yesterday. A few blocks from home the battery light came on, about the same time as the tire pressure updated. I figured the battery was low from sitting so much and we had take out ordered so we went on. Got to where we were going and I left the Commander running...
  3. General Commander Discussion
    Hello all. I have an 08 commander about 4 years ago I had the p41 ignition recall done. Now, when I run the truck hard( a lot of highway or start stop), when I turn the truck off it wont re-fire without a 5 minute cool down. when I turn the key It will sounds like the starter Bendix is stuck(...
  4. Problems / Dealer Service
    I have an 08 commander. I had the p41 recall done about 4 yrs ago, where they put in the new module and matched the new key fobs. Since then, I have intermittent starting issues. If I run the jeep hard or for a long time(highway driving), I stop, shut the truck off, it wont restart right away. I...
  5. General Commander Discussion
    2 hours before starting a trip, went to start, all the usual dash self check lights come on, turn to the start, and no start, at the airport now, and can't troubleshoot until I return in October. I have not searched the threads yet, but will over the next 3 months. I wanted to get this started...
  6. Regular Service / Maintenance
    I recently changed a starter in my wifes 2006 Jeep Commander and could not find a good "how to" on the web. There probably is one but I couldn't find a detailed one. So I figured I would post this to help the next guy out there. 1. Block rear tires 2. Jack up vehicle from jack point just behind...
  7. Regular Service / Maintenance
    I am trying to replace my starter on my 2006 commander (HEMI). I have disconnected the drive shaft, and I am trying to get the wheel well liner off so I can get to the wires. How do you remove all of these plastic rivets that are holding on the liner? I can not figure it out. thanks, Gary
1-7 of 7 Results
Top