Jeep Commander Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Bought set of 17in wrangler wheels with Bf Ats . They bolted up , with no visible issues. That is until I was going for a test run. The rear was fine ,the front scrub on the caliper. Do I need to just swap rear to front? Do I need spacers for the front? Any help will be greatly appreciated.
 

·
Super Moderator
2006 Commander Limited, 5.7 Hemi QD2
Joined
·
2,008 Posts
Check out this section - Wheels / Tires

Welcome to the forum. Please read this and fill in some of your details and make a signature with your Commander details. (year, model trim, engine, 4wd system, etc.) It is nice for us know what your Commander has in it so we can better help you.

NEW MEMBER REQUIRED READING!!! Important New Member information, Forum requirements & Forum rules. | Jeep Commander Forum

To make or modify a Signature click here - Signature - How to make or modify

To get the list of everything built into your Commander when built at the factory - have your VIN number (case sensitive) and go here Chrysler Build sheet - Equipment Listing Not necessarily for your signature but so you know what you have.

You can download a free Owner's Manual here--->Owner's Manual
 
  • Like
Reactions: nickbprice247

·
Registered
Joined
·
10 Posts
I did the same thing. I bought a set of I think 5 mil spacers for the front so they wouldn't hit the caliper.
 
1 - 3 of 3 Posts
Top