Jeep Commander Forum banner

2006/2007 Seat Swap

2249 Views 8 Replies 7 Participants Last post by  Stircrayzy
Hi All, Been lurking for a couple of years and have gotten some great info from you. But I just ran into an issue that I can't find any answers to.

I have a 2007 Jeep Commander with power drivers seat. Its on the way out. I bought a 2006 power drivers seat. Well... Different wiring harnesses. What am I to do? Do I need to purchase a whole new wiring harness? Can I cut out the harnesses and wire the wires directly? (I dont think that's possible because there are additional harnesses on the 06 that arent on the 07)

I'm lost, any suggestions?
1 - 1 of 9 Posts
@mamaminnesota
Welcome to the forum.

ATTENTION All Forum Members - Mandatory Requirement!

Please read this and fill in some of your details and make a signature with your Commander details. (year, model trim, engine, 4wd system, etc.) It is nice for us know what your Commander has in it so we can better help you.

To make or modify a Signature click here for instructions - Signature - How to make or modify

NEW MEMBER REQUIRED READING!!! Important New Member information, Forum requirements & Forum rules. | Jeep Commander Forum

To get the list of everything built into your Commander when built at the factory - have your VIN number (case sensitive) and go here Chrysler Build sheet - Equipment Listing Not necessarily for your signature but so you know what you have.

Also post an introduction in the "New Member" section. New Member Section

You can download a free Owner's Manual here--->Owner's Manual
See less See more
1 - 1 of 9 Posts
Top