Jeep Commander Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter #1
How do you get the moulding piece off on the back door of a 2006 Jeep Commander down by the wheel well, Mine is a limited with the chrome plugs that look like a allen wrench bolt but are just plugs, there are push clips that are under door when opened where weather strip is and ones inside door smaller ones on backside, I want to get them off without ruining them, Thanks Jerry
 

·
Registered
Joined
·
108 Posts
They should be held on by plastic rivits, the best way to remove them is to find a drill bit just a tad bigger then the small dot in the middle of the rivit and drill it out.
 
1 - 2 of 2 Posts
Top