Jeep Commander Forum banner
1 - 3 of 3 Posts

·
Registered
2006 Commander Limited 5.7 Hemi 4WD QD-II
Joined
·
11 Posts
Discussion Starter · #1 ·
I am trying to replace most or all of the suspension on our 2006 Jeep Commander 5.7 4wd. Its really loose and it feels like you are on a roller coaster on the smallest of dips on the highway. It shakes, rattles and rolls as well. So far I have done the following to the front:

2 front struts with coil springs
Both side upper control arms
Both side lower control arms
2 front sway bar links
Both side inner and outer tie rods
2 rack and pinion boots
Front differential mount (had alot of play in it) and bushings
Drive shaft cv joint

All of the above are Detroit Axle

For the rear I have ordered the following to be done this weekend:

Bilstein 5100 rear shocks
2 rear sway bar links

My question. What else can or should be done? Are the rear bushings difficult to do? Should they be done? Anything else recommended?
 

·
Administrator
Joined
·
15,438 Posts
Dang, seen by 198 but no replies?
A lot of those views are probably bots/spiders that pick up words/phrases when people are searching the internet. Anyway, take a look at your steering rack.
 
1 - 3 of 3 Posts
Top