Jeep Commander Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hello.

I took down the NAG1 transmission on my 2006 Jeep Commander 3.7L V6 because of an oil leak. I have since replaced the front oil seal and assembled the oil pan with a new filter and gasket. I just cannot mount the transmission to the engine block where the engine and transmission come together at the top. The other bolts I put in are M10 x 1.5 40 mm. I just cannot find a bolt to fit the top 4 bolts that hold the transmission to the engine block. I feel twice as stupid because I have no understanding of how the bolts I took off from the transmission with a 2 ft extension ++ some other extensions will not go back in.

All advice references and links are humbly received and more than greatly appreciated.
Thanks, Vivian:laugh2:
 
1 - 2 of 2 Posts
Top