Jeep Commander Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I just ordered a 50 inch light bar that I'm going to install on my roof. I'm curious as to how I'm going to run the wiring down to the battery. I was thinking it would just go down the door jamb but I'm not really sure how to get everything in the interior out so I can do that and where the wires should come through. Any comments and advice will be super helpful.
 

·
Super Moderator
Joined
·
5,882 Posts
I just ordered a 50 inch light bar that I'm going to install on my roof. I'm curious as to how I'm going to run the wiring down to the battery. I was thinking it would just go down the door jamb but I'm not really sure how to get everything in the interior out so I can do that and where the wires should come through. Any comments and advice will be super helpful.
You can run it right down the top of the door jam into the engine compartment and come in through the backside of the dash to the switch - that's the easiest, most direct way to do it.

I have a 50 inch curved LED light bar and that's how my wiring is run.
 
1 - 2 of 2 Posts
Top