Jeep Commander Forum banner

Added front recovery/winch points.

1162 Views 9 Replies 5 Participants Last post by  TNTJEEP
2
Pre paint. Using factory holes. Minor drilling to embigen the holes. Fits under the bumper. Minor trim needed to the plastic at the exit points.

Automotive parking light Tire Land vehicle Wheel Vehicle
. . Automotive tire Hood Motor vehicle Bumper Automotive design
See less See more
  • Like
Reactions: 3
1 - 10 of 10 Posts
@TNTJEEP Nice!

.
2
Looking good, pictures when finished please. I used this for the rear, might look good in front.

Automotive exterior Automotive tire Rim Gas Bicycle part
. . Microphone Gesture Networking cables Finger Gadget
See less See more
I got these, From amazon


Paint is drying right now. Should have them on in the next day or two.
See less See more
  • Like
Reactions: 2
@TNTJEEP Great job!

.
  • Like
Reactions: 2
Looking great
  • Like
Reactions: 2
I got these, From amazon


Paint is drying right now. Should have them on in the next day or two.
I have these on mine. I pulled a full size UPS truck up a hill in a foot of snow.
  • Like
Reactions: 4
Very Nicely done!
  • Like
Reactions: 1
Action shot! Sort of, didn't need to use them but it's a good view of them out in the wild.
42388
See less See more
  • Like
Reactions: 4
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top