Jeep Commander Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
72 Posts
Discussion Starter #1
The instructions say to remove the factory crank case vent hose from a T fitting (that I don't have) and replace it with a new hose (again. Don't have.) Then run it to the K&N tube.

Is the crank case vent hose the small hose I originally took off the filter/vent box? If so, check out my picture, I may just cut the solid part of the hose on order to make it work...

http://i1241.photobucket.com/albums/gg518/Sanders0492/Mobile Uploads/1392340594324.jpg
 
1 - 1 of 1 Posts
Top