Jeep Commander Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
79 Posts
Discussion Starter #1
I have a brand new pcm for the jeep commander that was programmed by b&g. The programming increases the rev limiter, higher top speed, shift points, and a few other things. I bought the pcm as a spare and sent it to be reprogrammed. The pcm cost me 400 and the tune cost me 350. I am looking to get about 600 for the tuned pcm or best offer.
 

·
Registered
Joined
·
79 Posts
Discussion Starter #3
I have two of them this one isnt installed but the one that I did really worked well. I have a few performance parts besides this and it uncorked them. The pcm is a real good performance upgrade. Also B&G is very good with their customer service. I have needed to contact them on my other pcm because I have done a lot of engine work and they needed to tune diferently.
 

·
Registered
Joined
·
1,561 Posts
Have to ask the question, I assume your PCM would only work for the 5.7?

Oh, and why aren't you starting threads on all of your mods? Shame on you. I didn't know anyone had done any real engine mods yet. All I've seen are CAI's and Catbacks.
 

·
Registered
Joined
·
79 Posts
Discussion Starter #5
no need to brag ahahahah.....and yea i think it would only work for 5.7
 

·
Registered
Joined
·
79 Posts
Discussion Starter #7
it is tuned for premium
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top