Jeep Commander Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
On my XK i currently have this setup:
Front:
JBA Upper Arms for Lifted
J & J Off Road Fab Diff Drop
Bilstein Adjustable at 1.5
OME HD 2991
1/2 inch spacer
No sway bar
Rear:
JBa 4 Inch springs
WJ front .75 spacer
Core 4x4 Upper & lower adjustable arms with adjustable track bar
Bilstein 5100 shocks
No rear swaybar.

My question is i scored a front Superlift lower crossmember, knuckles, and rear UCA drop brackets.
If i installed 2.5 front spacers and 2 inch rear spacers where would i be at with lift height? Having problems with the math. Shooting for 6-6.5 inchs of lift. Do i need to get the Superlift 4 inch spacers? Any info or help direction would be great.
 

·
Registered
Joined
·
193 Posts
The superlift needs the front spacers for the 4" lift, The taller knuckles put the front UCA into stock position after the 4" strut spacers are added. The cross member drops the LCA and the taller towers on the knuckles put the geometry of the UCA and LCA back to stock. Did you also get the SL skid plate? The skid plate is an important part of the cross member, it adds alot of strength. Why have you removed the front and rear sway bars? going up 6"+ will cause quite a bit of lean during cornering, not having sway bars will make your commander unsafe for highway use.
 
1 - 2 of 2 Posts
Top