Jeep Commander Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
602 Posts
Discussion Starter #1 (Edited)
Hi guys. Forgive my mechanical retardation, but I have a couple questions I've not seen posted about the 5100's.
1) do they make a strut for the front of our trucks? (Or GC possibly)
2) if so, since they are adjustable, could it be set up so that the 2" spacer (RC) could be eliminated??
3) are the 5100's valved the same as the yellows or are they stiffer or softer?
(Same question in regards to stiffness for the rear as well)


Thanks everybody

Sorry, just saw a thread regarding exactly this
 

·
Registered
Joined
·
1,585 Posts
They are listed only for the WK's, but I have some installed on my XK

.75", 1.5", 2" settings are possible

Same valving as yellows, NOTE: increased ride height inherently increases spring rate a bit(otherwise known as preload). Certainly "stiffer" than blown stockers.
 

·
Registered
Joined
·
602 Posts
Discussion Starter #3
They are listed only for the WK's, but I have some installed on my XK

.75", 1.5", 2" settings are possible

Same valving as yellows, NOTE: increased ride height inherently increases spring rate a bit(otherwise known as preload). Certainly "stiffer" than blown stockers.
Thank you much
 
1 - 3 of 3 Posts
Top