Jeep Commander Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Would anyone know where the block hetaer is located on a 2010 jeep commander 5.7 liter.Mine does not seem to be working.When i plug into the cord i can't here any noises as i should normally.It is -20 where i live .Or pictures of location would also be good.i followed cord to rear of motor and could go no further to see where it gets fitted to.Thank's in advance.
 

·
Super Moderator
Joined
·
15,109 Posts

·
Premium Member
Joined
·
6,309 Posts
I just installed an engine block heater yesterday on my Commander. Mine doesn't make any noise when plugged in. I had it plugged in overnight to test it out. It's located on the passenger side of the motor below the manifold closer to the firewall (not the front of the jeep) You can see it from under the jeep. When you look from the top of the engine compartment the wire disappears once it goes under the manifold. That's why you can't see it anymore from above.

When you started your jeep was the coolant gauge up to temp and blowing out warm air?
 
1 - 5 of 5 Posts
Top