Jeep Commander Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I am wondering if the 2010 Commander comes with a block heater. I have looked and looked and cant find a plug. and where I am it gets down to -35 and I have a hard time starting my jeep.
 

·
Super Moderator
Joined
·
14,914 Posts
The block heater is an option, so yours may or may not have one. See this thread---> http://www.jeepcommander.com/forums/showthread.php?t=373&page=12

From the Owner's Manual:

ENGINE BLOCK HEATER — IF EQUIPPED


The engine block heater warms engine coolant and
permits quicker starts in cold weather. Connect the cord
to a standard 110-115 volt AC electrical outlet with
grounded, three wire extension cord.
Use the heater when temperatures below 0°F (-18°C) are
expected to last for several days.
The engine block heater cord is located:



3.7L/4.7L Engine — coiled and strapped to the engine
oil dipstick tube.



5.7L Engine — bundled and fastened to the injector
harness.


WARNING!

Remember to disconnect the cord before driving.
Damage to the 110-115 volt AC electrical cord could
cause electrocution.
 
1 - 2 of 2 Posts
Top