Jeep Commander Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I pulled apart the brake light assembly with 2 friends and none of us could figure out how to get the replacement bulbs in and there is nothing in the manual. Any and all help is greatly appreciated. Thx!
 

·
Registered
Joined
·
52 Posts
are you talking about the taillights or the 3rd brake light at the top? if your talking bout the taillights you just twist the house and if pops right off....if ur talking bout the 3rd brake like, then i cant help u out.
 

·
Registered
Joined
·
480 Posts

·
Banned
Joined
·
277 Posts
Once you get the light housing off, you should be able to turn the wiring harnesses/bulb covers counter-clockwise and then pull them up out of the assembly housing. Then pop the old bulb out, new one in, and re-tighten clockwise to seal the housing. It's been a while since I changed mine, but pretty sure that's all there is to it...shouldn't be any brute strength involved - you'll break stuff then! haha. good luck.
 
1 - 5 of 5 Posts
Top