Jeep Commander Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I tore up one of the cv axels on Jeep recently and am wondering if there are any good upgrade cv axels out there. I have a two-inch body life on my commander and they don't seem to like the angle. Any brand recommendations would be appreciated. Thanks
 

· Super Moderator
2006 Commander Limited, 5.7 Hemi QD2
Joined
·
2,372 Posts
@calebhartman1
Welcome to the forum.

The following is required of all forum members.

Please read this and fill in some of your details and make a signature with your Commander details. (year, model trim, engine, 4wd system, etc.) It is nice for us know what your Commander has in it so we can better help you.

To make or modify a Signature click here for instructions - Signature - How to make or modify

NEW MEMBER REQUIRED READING!!! Important New Member information, Forum requirements & Forum rules. | Jeep Commander Forum

To get the list of everything built into your Commander when built at the factory - have your VIN number (case sensitive) and go here Chrysler Build sheet - Equipment Listing Not necessarily for your signature but so you know what you have.

Also post an introduction in the "New Member" section. New Member Section

You can download a free Owner's Manual here--->Owner's Manual
 

· Registered
Joined
·
69 Posts
Im confused what you mean by body lift? Surely that shouldnt change the angle of the cv's? I have a 2.5 inch spacer lift myself and the angle hasnt caused an issue yet. I often disconnect sway bars and climb up mountains around here. The stock CVs are pretty durable on the QD system. Are you sure they werent run without grease? Mine has a tear in the boot and Im sure eventually it will go, if all the grease leaks out.
 

· Registered
Joined
·
82 Posts
There are not any upgrades available outside of normal replacement brands. The stock ones are plenty strong for whatever you throw at them, and a 2” lift is not going to accelerate the wear enough to cause them to fail sooner than an acceptable amount.
 

· Registered
2010 Jeep Commander Limited 5.7L V-8; QD-II 4WD; 95,000 Miles
Joined
·
203 Posts
I tore up one of the cv axels on Jeep recently and am wondering if there are any good upgrade cv axels out there. I have a two-inch body life on my commander and they don't seem to like the angle. Any brand recommendations would be appreciated. Thanks
This place made upgraded CV axel sets a couple of years ago for the Commander/ Grand Cherokee. They don't currently list them but it's possible they could still make a pair for you. They were going for around $2k a pair. https://www.rcvperformance.com
 
1 - 5 of 5 Posts
Top