Jeep Commander Forum banner

cv axle

3K views 3 replies 4 participants last post by  Cubano36 
#1 ·
my 08 rocky mtn 4.7 qt2 had a uca ball joint failure which resulted in my wheel lying flat on ground. After replacing all damaged parts I don't know how to tell if it is a limited slip cv joint.IAlso when failure happened the long shaft was pulled out of differential.Is there a method to reattach shaft or does it just push in
 
#2 · (Edited)
@trackcar; Since you created another user profile (which is a violation of forum rules) your other user profile @Lehighosprey has been permanently banned.

I don't believe that the drive shaft just pushes back in place - but honestly, I'm not 100% sure.

I think you may have some other issues going on and you should probably consult a certified mechanic - rather then risking further damage to your XK.

I'd also suggest you read the New Member required reading very carefully and follow the forum rules going forward.

 
#3 ·
@trackcar , the cv axle just pushes back in to the diff.

.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top