Jeep Commander Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
I have an 06 5.7 Limited. Starting to hear a pop at 75% or more wheel turn so I guess its time to replace the front CV's. Does anyone out there have some insight as to what type (brand) to replace them with? Since I plan to put the 4" superlift on it, should I hold off doing this as I am not sure if it will need different lenghts at that point?

Thanks in advance
 

·
Premium Member
Joined
·
337 Posts

·
Premium Member
Joined
·
337 Posts
Glad that help.

Looking forward to seeing your photos with the SL installed !
 

·
Registered
Joined
·
18 Posts
Fwiw I had a napa replacement that 20k miles later is clicking, replaced the pem due to a ripped boot. I'm going back to a mopar oem replacement one, they seem to be tougher.
 

·
Registered
Joined
·
10 Posts
Just did the passenger side CV axle, with beefier RS4 axle. Guys - this job is a piece of cake.....once you take the time to remove the CV boot heat shield(three 6mm Allen heads). Stick a flat head screwdriver into the front rotor hole and freely turn/lock the wheel in neutral, completely without an assistant. Use a 3ft + breaker bar to get that final 180deg turn on the 17mm axle bolt and it's DONE!!!
 
1 - 7 of 7 Posts
Top