Jeep Commander Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
192 Posts
Discussion Starter #1
How do you remove the wire that goes to the head light? Do you pull it real hard? It looks like there are blue tabs on the sides and front..push in or pry out with screwdriver? I'm scared I will break it.
 

·
Registered
Joined
·
282 Posts
i just changed mine. i used a flathead screwdriver. i slid it between the tab and bulb housing. then pull down. one came straight off. i had to slightly wiggle one
 

·
Registered
Joined
·
862 Posts
Like tripod says... there's a locking tab that has to be released. The plug is also sealed to the bulb by a silicone based rubber, and it can be hard to pull out.
 

·
Banned
Joined
·
277 Posts
You do not need to touch the side blue clips, just the gray clip on the back side. I used a flat-head screwdriver to gently push the clip lock away from the bulb housing, then wiggled the clip down until it unlocked. hope that helps.
 

·
Registered
Joined
·
862 Posts
So... did one burn out? Or are you upgrading to Silver Star Ultra?
 
1 - 6 of 6 Posts
Top