Jeep Commander Forum banner

1 - 11 of 11 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hey yall Im Rob also known as Biggie I used to be a Certified Level 2 Jeep technician for about 6 years now i work for the city of NY now i have a Lifted 07 commander on 35's if you all have any jeep questions i will try my best to help.
 

Attachments

·
Super Moderator
Joined
·
5,882 Posts
Hey yall Im Rob also known as Biggie I used to be a Certified Level 2 Jeep technician for about 6 years now i work for the city of NY now i have a Lifted 07 commander on 35's if you all have any jeep questions i will try my best to help.
@Robert Biggie W

Welcome to the forum; that's a good looking XK; I was born & raised in Long Island myself.

I assume if you're running 35's that you have the 4 inch Superlift installed - or some modified version of it.
 

·
Registered
Joined
·
23 Posts
whats up rob welcome to the forum ! truck looks great. i am also located in queens near JFK airport and jamaica queens. maybe we'll run into each other one day lol
 

·
Super Moderator
Joined
·
5,882 Posts
i have the Modified ome and A lot of cutting and fabrication
It would be nice if you could take a minute when you have some time to elaborate on exactly what you did to clear those tires on a modified OME lift.

I have the 2 inch RC lift & I'm looking go up in tire size from P265/70/17's to LT285/70/17's which are 33's - not as big as the 35's your running obviously, but, about 1.3 inches or so bigger in diameter and about .8 inches wider than what I'm running now.

I know I'm going to have to do some cutting, just trying to get an idea of exactly how much.
 

·
Registered
Joined
·
9 Posts
Discussion Starter #9




There is a pocket in your wheel well on the fire wall side when you remove your wheel you will notice in you have to cut the out and hammer in the area next to it between you rocker panel and the pocket I used a 10lbs sledge hammer But I Will be Cutting that out and fiber glassing it to seal it. Below is the pocket cut out and the hammered in area


And also in the rear I cut out the weld completely and fiber glassed it back I took off about a inch
I’m used to cutting up jeeps so it doesn’t bother me to cut away lmfao below is the rear





Sent from my iPhone using Tapatalk
 
1 - 11 of 11 Posts
Top