Jeep Commander Forum banner
1 - 2 of 2 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
2006 3.0 crd . ( see attached photo) no fuel from high pressure pump . I have good fuel to and from the filter , but nothing from pump to rail .(manually powered pump to figure this out) Relay 2 is starter relay and according to the wiring diagram should pull in the pump , (relay 1 ) but on cranking nothing happens., ( relay works if powered ans swapped about to make sure) and no fuel to rail . Its been driving me crazy now for months please help
Motor vehicle Automotive tire Bumper Electronic component Engineering

· Super Moderator
2006 Commander Limited, 5.7 Hemi QD2
2,441 Posts
@Blaine135 You have been around for a while but please do the following.

The following is required of all forum members.

Please read this and fill in some of your details and make a signature with your Commander details. (year, model trim, engine, 4wd system, etc.) It is nice for us know what your Commander has in it so we can better help you.

To make or modify a Signature click here for instructions - Signature - How to make or modify

NEW MEMBER REQUIRED READING!!! Important New Member information, Forum requirements & Forum rules. | Jeep Commander Forum

To get the list of everything built into your Commander when built at the factory - have your VIN number (case sensitive) and go here Chrysler Build sheet - Equipment Listing Not necessarily for your signature but so you know what you have.

You can download a free Owner's Manual here--->Owner's Manual
1 - 2 of 2 Posts