Jeep Commander Forum banner
1 - 2 of 2 Posts

· Registered
2008 Commander 3.7L V6 QT-I
Joined
·
15 Posts
Discussion Starter · #1 ·
One of my studs that holds the coil pack down is spinning.
My question is can that stud come completely out and not drop anything into the motor?
 

· Registered
2010 Commander Sport; 3.7L V-6; 2WD; 240,000 Miles
Joined
·
8 Posts
One of my studs that holds the coil pack down is spinning.
My question is can that stud come completely out and not drop anything into the motor?
One of my studs that holds the coil pack down is spinning.
My question is can that stud come completely out and not drop anything into the motor?
One of my studs that holds the coil pack down is spinning.
My question is can that stud come completely out and not drop anything into the motor?
we have a 2010, 3.7 with the 3 coils on the drivers side only…often when that bolt is loosened up all the way until it feels like it’s doing nothing it takes a bit of a pop to get the retainer on the end of it to come out of the hole with the bolt. I use a big screwdriver or small pry bar to get some gentle leverage. It all seems to come out together once you get past that sticky point
 
1 - 2 of 2 Posts
Top