Jeep Commander Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
Ok I read through about every post I could find and did not find this one. I installed Notto se hid, high and low beam on my commander. ( after then reading I should not have done it on high beams to much shutting on and off)
Any way, with the included relays installed low beams work great, then when I use the hige beams for 10 mins or so, It doesnt matter where mannually or automatic turning the high beams on and off. They shut them selves off along with the radio then come back on in a split second with the low beams on, if i try it again same thing.

Any one have any ideas, I have checked for a bad connection with the wiring, and all looks good. Thanks......
 

·
Registered
Joined
·
1,796 Posts
I have no idea bud. Hopefully someone will have a answer.
 

·
Registered
Joined
·
11 Posts
Discussion Starter #5
Thanks I did forget to change it out to a bigger one, but which fuse is it? I looked in the manual and dont see which fuse is for headlights or highbeems. Maybe I missed it, will check again
 

·
Registered
Joined
·
43 Posts
i have a friend with an 08 dodge who had the same problem. they called the dealer and the fix is to also tap into the parking lights so that you have a constant power source. i believe they said it isn't constant on the headlights and thats why you get that flicker effect.
 
1 - 6 of 6 Posts
Top