Jeep Commander Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter #1
I just installed a set of JKS Quick-Disconnect's that I picked up from Rusty's and can NOT get these damn things not to clunk. They're greased well, I've mounted them perfectly even as well as tried pre-loading one side. Still, no change. I disconnected both sides to make sure it was in fact the disconnect's and everything was just as quiet as before. Potholes and uneven hits cause a thud that I'd love to get rid of.
 

·
Premium Member
Joined
·
66 Posts
The JKS disconnects are usually quite but when you start using a quick disconnect pin to retain the rubber bushing (instead of a nut and bolt), well, things can get a little noisy. The big Q is, is yours abnormally noisy or just "normal"?
 
1 - 2 of 2 Posts
Top