Jeep Commander Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
I just did an all around lift using Daystar's system. I ran into a problem with Monroe aftermarket struts and the plastic spacers did not fit on the aftermarket lift. I don't know if you are going that route. I ended up going with Bilstein all around, and the Polyurethane lift worked great on it. So a FYI. The stock rubber insulation was shot, that is why I went with the Daystar lift. It is way better, looks better, and rides even better.
 

·
Registered
Joined
·
141 Posts
I know this is a pretty old thread, but im looking for some thoughts and results from adding the Daystar kit to bilstein 5100 struts.
Specifically which strut setting and what are the final measurements you ended up getting?
 
1 - 2 of 2 Posts
Top