Jeep Commander Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,516 Posts
Discussion Starter #1
Check engine light is on, doing key dance, I get U1411. The only codes I seem to have are the p codes. What does U1411 mean?
 

·
Administrator
Joined
·
6,218 Posts
Did this occur after using your remote start?

smblk said:
Hello everyone.

We just purchased a used 2006 Commander Limited. I has about 6 months of warranty left. I haven't taken to the dealer yet. I wanted to do a little research before talking with the sevice department. I am an automotive mechanic from the 80's and know a little about todays technology (CAN OBDII).

When I picked up the Commander, there was no issues with the "check engine" light. We tried the remote start after getting home and the next time we drove the car, I noticed the "check engine" light was on (code U1411 - "Implausible fuel volume signal". After a few drive cycles the light went out. Tried the remote start the next day, and low and behold, the lights back on. I reset it manually. Next remote start, back on. See the pattern here?? I think it might occur when the ignition switch is turned to "on" after entering the car. I need to really analize the time the code is set vs. run time.

Has anyone out there experienced this issue and successfully had it fixed?
If so, what was the fix?

I am afraid this could turn into a real run around. Thanks, Jerry (smblk)
jeep5253 said:
A few other members have had this code come up when they have used the remote start. According to them it cleared after several starts with the key.
 
1 - 3 of 3 Posts
Top