Jeep Commander Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Finally got some much needed work done on The Beast. Lift and tires were on it when I bought it a little over a year ago and the remaining stock suspension components were worn bad. After seeing too many pictures of lifted Commanders with the upper ball joints broken that's where it started...
JBA UCA with ball joint for lifted XK, lower control arms with ball joints, struts, power steering rack, power steering pump, inner and outer tie rods, rear load leveling shocks and alignment done.
Did do a couple fun things to it - MBRP cat back exhaust and a Rola roof cargo rack...
 

·
Administrator
Joined
·
15,331 Posts
Thanks for the update, @RobTag .
 

·
Administrator
Joined
·
6,446 Posts
Finally got some much needed work done on The Beast. Lift and tires were on it when I bought it a little over a year ago and the remaining stock suspension components were worn bad. After seeing too many pictures of lifted Commanders with the upper ball joints broken that's where it started...
JBA UCA with ball joint for lifted XK, lower control arms with ball joints, struts, power steering rack, power steering pump, inner and outer tie rods, rear load leveling shocks and alignment done.
Did do a couple fun things to it - MBRP cat back exhaust and a Rola roof cargo rack...
@RobTag;

Sounds great, where are the pics??
 
1 - 5 of 5 Posts
Top