Jeep Commander Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter #1
I finished installing a pioneer avic-z1 in the commander. I took it out of my old truck. I mounted the GPS antenna next to the rain sensor on the dash. The Nav arrow looks like it was still on the last place it was when it was plugged in last. I went to settings and set my current location to where i was. When i drive the arrow does not move from that spot, the arrow just turns in place to show my heading. The reception for the GPS is like 7 out of 9 and it says OK. Also when it shows my speed it will say like 1.1 instead of 11mph or 4.5 instead of 45.

What do i need to do?
 

·
Banned
Joined
·
1,397 Posts
I'm not completely familiar with the Pioneer navigation units, but did you have to hook up a speed sensor wire? Also, did you have to hook up a reverse sensor wire?

I had to hook up both of those wires in my 4Runner to get my OEM navigation system to work properly.
 
1 - 4 of 4 Posts
Top