Jeep Commander Forum banner

1 - 5 of 5 Posts

·
Registered
2006 Limited 4.7 Quadra-Trac II
Joined
·
5 Posts
Discussion Starter · #1 ·
Hey, I’m new here. I’ve been reading the forums for years and finally decided to join. I have a 2 inch lift spacer already. I’m now switching over to Bilstein 5100 shocks. The front shocks are adjust and I’m planning on setting them to 3/4 inch(it’s the lowest setting other than stock) but I’m scared I’m going to start tearing stuff up. I already replaced my UCAs to JBA off-road ones and I love them. If y’all could help me out that would be great.
 

·
Administrator
Joined
·
15,875 Posts
@Roosevelt Please3 make an introductory post in the New Member Section. Thanks.

.
 

·
Registered
2006 Limited 4.7 Quadra-Trac II
Joined
·
5 Posts
Discussion Starter · #4 ·
Did you replace the coil springs with aftermarket?
I have not replaced the front coils with any upgraded aftermarket ones. Only oem replacements. The front springs and shocks have been replaced because they were severely worn out when I bought the car. The rear shocks have already been replaced to the Bilstein 5100s
 

·
Registered
2006 Limited 4.7 Quadra-Trac II
Joined
·
5 Posts
Discussion Starter · #5 ·
Here is my 2006 Jeep commander 4.7 with QT-II. It has a 2 inch RC lift, JBA UCAs, 2016 grand Cherokee wheels, 285/65r18 Nitto Ridge Grappler tires, AFE power cold air intake, Diablosport predator 2 programmer, and cat back straight exhaust.
42639
42640
 
1 - 5 of 5 Posts
Top