Jeep Commander Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
My Jeep has an aftermarket oil cooler installed that has sprung a leak. My mechanic suggested removing it and re-installing the OE plugs. Any advise on removing or replacing it? It was installed before I bought it, so I'm not certain which oil cooler it is. If I should replace it, can anyone give me suggestions on which brand I should get?

I have a
2007 Jeep Commander Sport 4.7 L, with a
5.7 L radiator
 

·
Registered
Joined
·
19 Posts
Discussion Starter #2
All I can find are universal fit. Dorman, or B&M. Can't seem to find any direct fit.
 

·
Registered
Joined
·
19 Posts
Discussion Starter #6 (Edited)
My mechanic said it was leaking up by the condenser. He took it off, and fixed the leak. I picked it up today, but then had to take it right back. My CEL came on with a DTC P 0300. I'd take some pics of the cooler, but I left it in a box inside the Jeep.
It's got new plugs/wires
New coils
New Crankshaft position sensor, might be a little while tracking down the problem unfortunately. ��
Just had a new front drive shaft put in, control arms, ball joints, brakes all around, and the airbag module replaced.
Hope to have it back soon
 
1 - 8 of 8 Posts
Top