Jeep Commander Forum banner
1 - 4 of 4 Posts

· Registered
2006 Jeep Commander sport 3.7 qt-1 210,500 miles
Joined
·
36 Posts
Discussion Starter · #1 ·
I recently had a cel pop up with a P0440. I purchased a brand new gas cap considering it was cheapest and easiest to do and didn’t fix it. Next I’m going to replace the eve app control valve. Where is this located I cannot find anything on the Internet. Is it in engine bay? Or under car in rear? Thank you….John
 

· Registered
Joined
·
86 Posts
Engine bay, driver side mounted to the fuse box behind batt

Do you ever smell raw gasoline? A code p0440 indicates a small leak anywhere past the charcoal canister. This could be a leak in the gas tank itself (fuel pump o ring, evap hose ring, or vacuum lines, filler neck etc.) Less commonly, the vacuum lines in the engine bay or a cracked charcoal canister. You can test the evap purge valve manually using a scantool, before running out and wasting money on a replacement.
 

· Registered
2006 Jeep Commander sport 3.7 qt-1 210,500 miles
Joined
·
36 Posts
Discussion Starter · #3 ·
Ok thank you. I will check everything over good tomorrow. Hopefully I can figure it out. It runs fine no issues. Just hate seeing the cel on. I don’t ever smell raw gas either.
 

· Registered
2006 Jeep Commander sport 3.7 qt-1 210,500 miles
Joined
·
36 Posts
Discussion Starter · #4 ·
So I just seen both hoses popped off of it probably when I was working on it the other day in that area. I hooked them back up. Cel still on but I guess it might take a little bit to go away. If I try to clear it with my code scanner, it won’t erase.
 
1 - 4 of 4 Posts
Top