Jeep Commander Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
I've been looking around trying to find them and so far I have nothing. I recently replaced the front bushings but a new sound which I believe I've isolated to my rear sway bar. Any input on where and what size? It's a 2006 4.7 limited.
Thanks in advance
Derrick
 

·
Registered
Joined
·
24 Posts
Discussion Starter #2
Correction... I think it's the coil spring insulator on the rear. Has more of a squeak than a clunk. I also disconnected the rear sway and took it around the block and the noise was still there.
 

·
Registered
Joined
·
554 Posts
maybe try to spray the suspected area with wd40. if the sounds changes or goes away, you know wher to go.
 

·
Registered
Joined
·
24 Posts
Discussion Starter #4
I broke it down yesterday and after removing the coil spring I can see the insulators are pretty tattered so I placed an order for new ones. I hope that's it and not a control arm bushing or something more difficult. I've never had a vehicle destroy bushings in 15 years as much as this one has in 7.
 
1 - 4 of 4 Posts
Top