Jeep Commander Forum banner

1 - 5 of 5 Posts

·
Premium Member
Joined
·
2,629 Posts
You will need to either get a tool to hold the water pump pulley or just use your hand and then use a large wrench on the nut that sticks off the front of the pulley (attached to the fan) and just loosen the nut until the fan is free
 

·
Premium Member
Joined
·
2,629 Posts
the tool is "special" but its not a big deal. It is basically a bar with two tabs sticking out. I made my own out of a flat bar with two bolts through. The bolts fit into the holes on the pump pulley and help you hold it from turning. I cannot remember the turn direction loosens the fan but maybe someone else does. Also you can look at how the fan turns to figure out which way it goes....
 

·
Registered
Joined
·
68 Posts
Discussion Starter #5
ok thanks that wat i was assuming the holes were for. i appreciate the advice last question. the bolt will lossen the opposite direction of the fan?
 
1 - 5 of 5 Posts
Top