Jeep Commander Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter #1
I have a 2006 commander with Hemi and quadra drive II..does anyone know the correct size of the hex or allen bit to check front differential and is it metric or standard...thanks RKL
 

·
Registered
Joined
·
862 Posts
I found a bolt (head) that fit. I used an oxy/acetylene torch to heat it up, and made a short 'L' out of it. Only an individual Allen will work, a folding set is way to long. And, you may have to cut off the short side of that big of an Allen at that. It's close quarters under there.

The 14mm sounds about right, as the bolt head is around 1/2''
 

·
Premium Member
Joined
·
691 Posts
Just did mine 30 min ago. Its a 14mm.
 

·
Banned
Joined
·
90 Posts
if your 14mm allen socket is too long to fit the ratchet on it, you can hold the socket in place, then use a 14mm open-end wrench to turn the allen socket.
 
1 - 6 of 6 Posts
Top