Jeep Commander Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
142 Posts
Discussion Starter #1
i have a spacer lift that will fit a WK or XK. the front are 1/4" steel plates, 2 sets, and the rear is a steel spacer that measures 1-1/2". i used it as part of my stacked setup. $100 plus actual shipping. local pickup is ok in the SF bay area
 

Attachments

·
Registered
Joined
·
241 Posts
What brand is the spacer lift? Height?
 

·
Registered
Joined
·
142 Posts
Discussion Starter #3
The front plates are from rusty's, and I don't recall who makes the rear spacer. I remember I had a hard time finding a steel spacer. I found it as a "kit" and called the company and asked them to split it up as I only wanted the rear. Sorry I can't recall the company. And as stated before, the fronts are 1/4" and the rear is 1.5"
 

·
Super Moderator
Joined
·
14,915 Posts
Do you happen to still have these? I know it's been a while. I don't actually need the parts, I need a tracing of the spacer plate, because I need to make a 1/8" thick copy of one.
@dodgerr, the last post in this thread was THREE years ago and Trax95008 has not been active on the forum since 08-19-2016. I am closing this thread.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top