Jeep Commander Forum banner

1 - 3 of 3 Posts

·
Banned
Joined
·
13 Posts
Discussion Starter #1
Hi guys. I just recently put some BF Goodrich ATs (I don't remember the size) on the Commander and sometimes when I'm giving a u turn the trac light blinks on and off and It feels like I lose power for a couple of seconds until the light stops blinking and when I straighten the jeep wheels out, everything goes back to normal. Should I be concerned about this? Again it's only when i make a turn that makes me turn the steering wheel all the way.

It's a 2WD v6 with stock height. No lift. Also the tires arent much bigger than the stock ones. I got the size from one of the other boards on here from another member.

Also I've never had this problem before with the stock sized tires.
 

·
Premium Member
Joined
·
294 Posts
Tire Size

When I changed tire size I recalibrated the speedo and trans for the new size and it had choices every 1/4 of an inch, so when cornering one tire goes farther around the corner than the other and that may confuse the P.C.M. and give the light/control.

Swanny
 

·
Registered
Joined
·
139 Posts
Yep same thing i was thinking. Need to cal thst tire setup. Also check the wheel hub sensors make sure they are securely plugged in
 
1 - 3 of 3 Posts
Top