Jeep Commander Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have a 06 commander limited with 4.7 awd. I just recently had the timing chains repaired at the stealership. While driving home my traction control activated at 40 mph and would not allow me to accelerate past 40. Lost all power. I turned the traction control off and it drove fine. Also I have had some humming coming from the front end that has gradually progressed. Maybe a coincidence but is it possible I've lost a hub bearing and a speed sensor.

Also I have no abs or traction control trouble codes.

Also I had the ignition recall and both 4wd reflashes done at the same visit.

Furthermore I Def don't think it's related except maybe a couple wire in the same loom but my oil light has been intermittently coming on but going off after restart. No motor knocking and oil level is fine. And since you have to drop the oil pan for the timing chain repair it has fresh dealer oil. The oil system was also flushed. I figure worse case senario I have shaving in the oil pump screen and electrical issues with the trac control. Best case bad wheel speed sensor and bad oil pressure sending unit.

Any comments or help?
 

·
Registered
Joined
·
210 Posts
when is the last time you had a front diff fluid change?
 
1 - 2 of 2 Posts
Top