Jeep Commander Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,585 Posts
Discussion Starter #1 (Edited)
Ok, I'm looking @ a set of custom wheels and tires from a JK

I plan a RC 2.25" lift to accomodate these.

Factory JK tire height 255/70r18, and I am aware that the pinchweld will likely need addressing, but the wheel is 18x9 with 5.39" backspacing, will this be a concern with the bolt? If possible I would prefer to not run spacers.

Our factory wheels are 17x7.5 iirc with 6" backspacing. So the wheel should be .61" further from the bolt, allowing for more clearance correct? As far as the wheel sticking out this should be nearly the same as running a 2"+ spacer (as the wheel is 1.5" wider)? Just making sure I'm thinking of this correctly.

WHEEL WIDTH UOM: in. | WHEEL WIDTH: 9 | WHEEL SIZE: 18x9 | WHEEL DIAMETER UOM: in. | WHEEL DIAMETER: 18 | OFFSET UOM: mm | OFFSET: 10 | MEASUREMENT TYPE: SAE | MATERIAL: Aluminum | MARKETING COLOR: Carbon Black with Machined Accent | COLOR: Black | BORE DIAMETER UOM: mm | BORE DIAMETER: 83.7 | BOLT PATTERN UOM: mm | BOLT PATTERN: 5x127 | BACKSPACING UOM: in. | BACKSPACING: 5.39 | Description: wheelWHEEL WIDTH: 9
 
1 - 2 of 2 Posts
Top